Safety operating rules for robot water jet cutting of automotive interior 

(1) The area around the robotic water jet cutting workstation must be clean.

(2) Do not wear (gloves) to operate the teaching panel and operation panel when operating the machine.

(3) If it is necessary to manually control the water jet cutting robot, ensure that the water jet cutting robot is within the range of motion (without any personnel or obstacles), and then gradually adjust the speed from slow to fast to avoid sudden changes in speed and cause damage or loss .

(4) Before executing the cutting program, make sure that there should be no irrelevant (personnel, tools, articles) in the working area of the car interior robot, the workpiece (clamping) is reliable and confirm (the cutting program and the workpiece) correspond.

(5) The cutting speed of the robot is relatively fast, which is dangerous. The operator should be responsible for maintaining the normal operation of the workstation (non-workers are strictly prohibited from entering the work area).

(6) During the operation of the water jet cutting robot, operators are strictly prohibited (leave the scene) to ensure that (in case of accidents) they can be dealt with in time.

(7) When the robot jet cuts automotive interior parts, the operator should pay attention to the condition of the water jet cutting coil.

(8) The cables of the robotic water jet cutting workstation should not be severely bent into a twist or rubbed against hard objects to prevent the internal core from being broken or exposed.

(9) The robot teach pendant and cables cannot be placed on the (water jet cutting platform), they should be (carried with hand) or (hanged in the operating position).

(10) When the robot stops working, don't think that it has finished its work, because the machine is probably (waiting for the input signal to keep it moving).

(11) Before leaving the working area of the equipment for some reason, press the emergency stop switch (to avoid sudden power failure or loss of zero position during shutdown), and place the teach pendant in a safe position.

(12) At the end of the work, the manipulator should be placed in (zero position) (or safe position).

(13) It is strictly forbidden to place it (accessories, tools, sundries, safety helmets, etc.) in the control cabinet, so as not to affect some circuits and cause abnormal equipment.

(14) Strictly observe and implement the (daily maintenance) of the machine.

(15) When the water jet cutting starts, check the high-pressure water circuit to ensure that there is no water leakage in the high-pressure water circuit.

WIN-WIN robot water jet cutting not only provides you with a car interior water jet cutting robot solution, but also trains relevant operators for you to put your equipment into production better.

The above is the relevant introduction about the safe operation rules of robot water jet cutting of car interior. Please remember these safe operation rules of water jet cutting of car interior robots to ensure safe and effective operation of water jet robots.