80073646 Waterjet HP Cylinder Nut - HSEC .88 Plunger HSEC Units

• Part Name：Waterjet HP Cylinder Nut - HSEC .88 plunger HSEC units
• Part Number：80073646
• Introduction：There is a low-pressure water inlet hole on the end cover of the 80073646 waterjet HP cylinder nut, and the sealing head body is connected to the side of the high-pressure cylinder. After connecting the water pipe, the low-pressure water enters the sealing head body from the end bell of the high-pressure cylinder, and then enters the high-pressure cylinder block. Pay special attention to the threaded holes on the end caps. When installing these screws, you must install them in accordance with the rules and tighten them clockwise. The first time is 27NM and the second time is 43-47NM. The maximum design torque is 51NM. Please do not exceed this torque.